BTC Flip Bot V1 — MTF + SL-Flip

BTC Flip Bot V1 — MTF + SL-Flip at a glance

Kind of rule	Joining a move (trend following)
Buys or sells	It can buy, and it can bet on falling prices.
Built on	ATR, Donchian Channels, EMA, MACD, RSI, SMA
Where it was published	TradingView, by its author, as a Pine Script strategy
Tested on	38 cells: 15 coins, October 2021 to June 2026, no fee
Cells that placed a trade	34 of 38
Middle result before fees	−38.0%
Cells above zero	10 of 34
Middle drawdown before fees	73.2%
Page updated	2026-11-08

BTC Flip Bot V1 — MTF + SL-Flip backtest results, every cell

Every cell is in the picture, not only the strongest. To the right of the black line is above zero. The orange line, when you see one, is the middle.

How BTC Flip Bot V1 — MTF + SL-Flip works

Rules in this group usually work like this. It waits until price is already moving, then joins that move. It is wrong in small ways many times, and right in a large way a few times. The hard part is the stretch where price chops around and every entry is a fake. The next paragraph is this particular rule, which can be narrower than the group.

It can buy, and it can bet on falling prices. It acts only when several checks agree at once. It leans on ATR, EMA, MACD, RSI; those names are explained on their own pages, further down. The exact line is in the list below, in the author's names, and you can skip that list. When it enters, it also sets a stop or a target, so a trade can close without a new signal.

Each trade uses the whole account. It holds one trade at a time.

The exact condition, from the code

Same rule, translated from the code, in the author's names. You can skip this list if the paragraph above was enough.

• Enters short when Enable SL-flip (on) and pending flip side differs from 0 and no position is open and (the bar index − pending flip bar) is at or above Flip wait (hours) (1) and not (the bar index is below (the bar index + Halt duration (hours) (168))) and not ((the bar index − last exit bar) is below Generic exit cooldown (hours) (2)) and pending flip side equals −1 and (((equity × Leverage (2)) / the close) when (the smaller of ….
• Enters long when Enable SL-flip (on) and pending flip side differs from 0 and no position is open and (the bar index − pending flip bar) is at or above Flip wait (hours) (1) and not (the bar index is below (the bar index + Halt duration (hours) (168))) and not ((the bar index − last exit bar) is below Generic exit cooldown (hours) (2)) and not (pending flip side equals −1) and pending flip side equals 1 and (((equity × Leverage (2)) ….
• Enters long when long stack and daily close is above daily ema50 and rsi4h is above 50 and not ((the bar index − last long stop bar) is below Same-dir SL cooldown (hours) (24)) and not ((the bar index − last exit bar) is below Generic exit cooldown (hours) (2)) and not (the bar index is below (the bar index + Halt duration (hours) (168))) and no position is open and (((equity × Leverage (2)) / the close) when (the close − the larger ….
• Enters short when short stack and daily close is below daily ema50 and rsi4h is below 50 and not ((the bar index − last short stop bar) is below Same-dir SL cooldown (hours) (24)) and not ((the bar index − last exit bar) is below Generic exit cooldown (hours) (2)) and not (the bar index is below (the bar index + Halt duration (hours) (168))) and no position is open and (((equity × Leverage (2)) / the close) when (stop short − the ….
• On entry, places a stop at the smaller of (the highest high of the last 10 bars × (1 + (SL buffer (%) (0.1) / 100))) and (pending flip ref × (1 + (Flip SL cap (%) (1.5) / 100))).
• On entry, places a stop at the larger of (the lowest low of the last 10 bars × (1 − (SL buffer (%) (0.1) / 100))) and (pending flip ref × (1 − (Flip SL cap (%) (1.5) / 100))).
• Closes the position when is flip position and a position is open and (the bar index − flip entry bar) is at or above Flip time-stop (hours) (24).
• On entry, places a stop at the larger of (the smaller of the low and the previous low × (1 − (SL buffer (%) (0.1) / 100))) and (the close × (1 − (SL max (%) (2.5) / 100))).

Buys or sells	It can buy, and it can bet on falling prices.
Tools it calculates	ATR, Donchian Channels, EMA, MACD, RSI, SMA
A second chart speed	Yes. It also looks at a second chart speed.
Only at certain hours	No.
Adding to a trade	It holds one trade at a time.
How much it trades	Each trade uses the whole account.
Cost the author assumed	The author assumed a trading cost of 0.04 percent per side.

Default settings

The test used the defaults in the middle column. Nothing was turned to help a coin.

Setting	Default	Group
Leverage	2
Risk per trade (%)	1
Drawdown halt (%)	25
Halt duration (hours)	168
SL max (%)	2.5
SL buffer (%)	0.1
TP trigger (R multiple)	6
TP close (%)	15
Move SL to BE+buf (%) after partial TP	0.1
RSI long min	45
RSI short max	55
Engulf body multiplier	1
ATR MA length	50
Volume SMA length	20
Volume spike ratio	1.5
Same-dir SL cooldown (hours)	24
Generic exit cooldown (hours)	2
Clean view (minimal — only signal arrows)	on
Show Daily EMA50 line	off
Show entry signal arrows	on
Enable SL-flip	on
Flip wait (hours)	1
Flip SL cap (%)	1.5
Swing lookback (bars)	10

and 1 more settings, left at the author's defaults.

How the backtest was run

Every strategy was tried the same way, on the settings the author published.

The years are October 2021 to June 2026. The prices are from Bybit, for 13 widely traded coins, mostly on hourly, 4-hour and daily charts, with some faster charts. That was 47,242 tries. The window stored in the files is 2021-09..2026-06.

599 rules produced a finished try. A rule that finished above zero on at least 12 cells, before any fee, was tried again with a fee of 0.12 percent per side. Only buys are counted in that second try. 273 rules got it.

The method, the aggregate results and a downloadable table are on the study page. What the desk does with the results beyond these pages is its own.

Before any fee, it was tried on 38 cells. It placed a trade on 34 of them. 10 of the cells that traded finished above zero (29.4%).

It was not run a second time with a fee. That second pass happens only when at least 12 cells finished above zero before fees. 273 rules got that pass.

Cells tried	38
Cells that placed a trade	34
Finished above zero	10 (29.4% of the cells that traded)
Middle result, before fees	−38.0%
Strongest cell, the top of the range	XLM 4-hour: +498.5%
Weakest cell, the bottom of the range	ADA 30-minute: −100.0%
Middle drawdown, before fees	73.2%

Label: backtest · old prices, zero commission · Oct 2021 – Jun 2026. Hypothetical results; see the risk disclosure.

How to read the result

How to read the number

The median of every cell that traded is the result. No fee has been taken off, so the number is a ceiling. A fee comes off each trade, and this page does not guess that cost, because this rule did not get the second pass where the fee is applied. The weakest and the strongest cells are not a result on their own.

The middle drawdown, on the cells that traded, was 73.2%.

What this does not show

The useful question, for a rule that joins a move already underway, is what it gave back in the choppy months when there was no trend to join.

Nothing on this page was fit to the cell that finished highest. One coin, one chart speed, or one strong stretch is a single row. It is not the rule. Other years, another exchange, or another fee would be a different measurement.

Questions about BTC Flip Bot V1 — MTF + SL-Flip

Words used on this page

Backtest

The rule was tried on old prices. No real money moved.

Cell

One coin on one chart speed. Bitcoin every 4 hours is one cell. Bitcoin once a day is another.

Chart speed

How often a new price bar is drawn. 15m means every 15 minutes, 1h means hourly, 4h means every 4 hours, 1D means once a day.

Fee, per side

A cost taken each time the rule trades. Per side means once on the way in and once on the way out.

Median

Line the cells up from the biggest loss to the biggest gain. The median is the middle one. Half the cells did better and half did worse.

Drawdown

The deepest fall from a high point along the way, as a percent of the account at that high.

Above zero

The account finished with more than it started.

The indicators BTC Flip Bot V1 — MTF + SL-Flip uses

Each has its own page: what it measures, how it is read, where it misleads.

• ATR (average true range): the volatility number behind most stops
• Donchian Channels: the highest high and lowest low, and the breakout rule they define
• Exponential moving average (EMA): what it measures and where it misleads
• MACD: two EMAs, a signal line and a histogram, read correctly
• RSI (relative strength index): the formula, the 70/30 rule, and why it misleads in trends
• Simple moving average (SMA): the plainest average, and why it still runs half the strategies

"BTC Flip Bot V1 — MTF + SL-Flip" was published on TradingView by its author, under the author's own license. This page is an independent reading of those rules and of what they did on these old prices. It is not written with the author, and it is not a recommendation. Not every detail survives the translation onto this page, so read the original before you rely on it.